Search the Community

My Epson TM-M10 It prints everything a bit too far to the left and leaves too much space on the right margin. I added the following ESC/POS command 1B,61,01 It kinda works because it centres all the text which is not really what I want. I prefer to move everything about 3-4mm to the right. Anyone know what ESC/POS command to use for that? My printer is set up as an other printer. PS. I have gone through every setting and adjusting the paper width but 48mm is the max setting I can use.

Hello, For anyone having trouble with their bills print being cut off from the right, the following command will help: B6,6C,9A just write in the Initial ESC/POS commands area in advanced settings Also you can find more command info that might help other situations in: http://www.ekka.com.ua/files/doc/ma501_4421_00_rev14.pdf Hope it helps! NOTE: Just to clarify, i do not own the MP-4000 TH POS Printer mentioned in the manual, but most commands did work for my off-brand Bluetooth thermal printer, so it might also work for yours

Hi, I have the issue when bill printing completed, I tear the bill and the tear line fall on last printer line. How to auto feed paper further after the bill printing completed?

Hello everyone I would like to change the POS commands in the app to open the cash drawer. The command for my MUNBYN bluetooth printer is 27,112,0,50,250 , but LOYVERSE app will not allow the entry of more than 2 digits before a comma, 3 digits can not be entered before a comma. Any assistance is greatly appreciated.

After turning my receipt printer on, it prints perfect receipts for the first order. It also lets me print multiple receipts for the first order and they are all fine. For the second and subsequent orders the receipts are gibberish. If I power cycle (off then on) the printer in it will once again print the first order perfectly, but reverts to printing garbage on all subsequent orders. The printer is a generic thermal printer with usb, serial, ethernet and WiFi interfaces. I am currently using WiFi. The issue exists whether I use an Android tablet or my smartphone. Presumably, I need to send some sort of start up command sequence to the printer in order to intitialise it. Has anyone experienced this type of problem or can anyone offer a suggestion as to how I can rectify this issue?

I know this has been asked a thousand times already... I have followed the instructions to change the printer to "other model" and use the Initial ESC/POS commands as 1C,70,01,00. That did not work. Saw that someone else recommended using the Hex code for the image in the Initial ESC/POS commands. But I am unable to find the Hex code in the Epson Utility. Has anyone gotten it to work with the T88V? or have any other solutions?