Hello, Thanks again for the response. Unfortunately, the problem is not that i do not know what the command is, but rather which section should I put it eg. should I put the command in Initial or Cutter or Drawer section?

Hi, thanks for directing me to this post I've read this thread before, in fact I've tried to add, for example, 1D,4C,50 in Initial/Cutter/Drawer section, but to no avail The printer would print garbage instead

Hello, Is it possible to set the left margin using ESC/POS Command ? I understand that I can add ESC/POS Commands in Advanced Settings (Initial / Cutter / Drawer commands) I've also found that the code to set the left margin for my printer is : ASCII GS L nL nH Hex. 1D 4C nL nH Decimal 29 76 nL nH Can anyone show me where to apply those codes? or any other codes to set the left margin Thanks Budi

Hi, lets say i had an open ticket, saved it, commented on it.. then completed the sale I'd like to see these saved ticket names and comments in the exported report (.csv) Is there a way to do that ? Thanks Budi